| Item | Data |
| Application | Vertical |
| Installation Mode | Add-on |
| Table diameter(mm) | ∅170 |
| Inner diameter of mandrel sleeve(mm) | ∅40H7 |
| Diameter of center through hole(mm) | ∅40 + ∅52deep |
| Center height (Vertical)(mm) | 135 |
| Table T-slot width(mm) | 12H7 |
| Guide block width(mm) | 18H7 |
| Transmission Mechanisms | Worm & Worm Gear |
| Min. increment(deg.) | 0.001 |
| Indexing precision(sec.) | 20 |
| Repeatability(sec.) | 6 |
| Clamping system (MPa / kgf/cm²) | Hydraulic (3.5 / 35) |
| Clamping torque(N·m / kgf·m) | 640 / 65 |
| Servo motor model(FANUC)(straight shaft without key) | αiF4 / αiF6 / βiF8 |
| Servo motor model(MITSUBISHI) | HG – S4 / J4 |
| Speed reduction ratio | 150 |
| Max. rotation rate of table(min⁻¹) | 44.4 |
| Allowable inertia load capacity (vertical)(kg·m²) | 0.63 |
| Allowable workpiece load (Vertical)(kg) | 75 |
| Allowable workpiece load (with support table)(kg) | 150 |
| Allowable thrust load (with rotary table clamping) F (N / kgf) | 14225 / 1450 |
| (Axial) *1 Allowable thrust load (with rotary table clamping) Fx (N·m / kgf·m) | 1079 / 110 |
| (Radial) *2 Allowable thrust load (with rotary table clamping) Fr (N·m / kgf·m) | 304 / 31 |
| Driving torque(N·m / kgf·m) | 264 / 26 |
| Net weight (servo motor excluded)(kg) | 60 |
| *1 | If a mechanical brake is not used, this value will correspond to the motor’s holding torque. |
| *2 | The structural limit value, while the actual operating speed will vary depending on the motor. |
- Description
